The CHUGGER PUMP® Stainless Steel Center Pump 230V is a homebrew beer pump which is typically used to transfer hot and/or cold liquids between brewing vessels.
Inlet 3/4" MPT Outlet 1/2"MPT
316 STAINLESS STEEL (Front Housing), 316 Stainless Steel (Rear Housing), Teflon (Thrust Washer), CLEAR Silicone (O-Ring), Ryton/Teflon Impeller
Max Flow 7 GPM 26.5 LPM
Max Head 18.6 FT 4.1 M
Power 1/20 HP (.04 HP) .029 KW
Electrical 230V 50/60HZ
Motor AMP Rating - Full Load Amps (FLA)
Motor Only: 1.7 Amps
Motor and Pump: 1.9 Amps
Can handle liquids of 250F
Materials are FDA Food Compliant
Components are UL Recognized
The CHUGGER PUMP® is shipped ready for installation. Directional arrows on the pump head show fluid direction through the pump. The four screws on the pump head may be removed and the pump head can be rotated as required to fit your piping system. Check out "How to Change a Chugger Pump Orientation Video".
The motor should be oiled yearly with 4-5 drops SAE20 weight non-detergent oil, do not over oil.
Follow all local electrical safety codes and always disconnect power before performing work on or near the pump motor.
CHUGGER PUMP® is warranted only against defects in workmanship for a period of 6 months from the date of purchase. DO NOT RUN THE PUMP DRY, it will not be covered under warranty. A SQUEALING SOUND IS A WARNING YOU ARE RUNNING THE PUMP WITH NO FLUID!!!! POWER OFF IMMEDIATELY!!! DO NOT PLUMB INLET TUBING OR CONNECTIONS WITH LESS THAN 1/2" FULL PORT FITTINGS. THIS WILL RESULT IN CAVITIATION AND PROBLEMS WITH YOUR PUMP!!!!